• en
  • fr
  • ja

Compass Angled Brake Washer (Pair)


These washers are easy to retrofit on older Compass and even classic Mafac brakes. With this system, you to adjust toe-in only once, when you initially set up the brakes, and then never worry about it again.

It’s really simple: The washer that goes under the posts of the brake pad has one groove that is deeper than the other. This puts the brake pad at a 2.5° angle, which gives you about 2 mm of toe-in. There is a dot on the reverse (invisible once installed) that shows which groove is deeper. Install the washer in the orientation that you want your toe-in, and you are done. The washer remains in place as you adjust or change the brake pads, so you never have to think about it again. Your toe-in always remains the same.

In stock

Categories: ,
  • Compatible with Compass Centerpull, Mafac centerpull brakes, and others with similar "post-style" pad hardware
  • Not compatible with most modern brakes.
  • 1 gram each